accel-ppp.org

Hello Martin, I'm having the same problem here, some IPoE interfaces fall and become trapped and begin errors "IPoE: nl_create: error talking to kernel" or Accel is sending Nak for new requests. It works well for a few days and then start the daemon problems and sometimes also for, being n...

Hello everybody, I'm having having a means annoying problem here . Everything was working fine, but two weeks ago I started receiving complaints from customers who were not able to authenticate and soon realized that these customers received NAK message when did the IP request to the accel server, s...

Hello Dmitry, Solve the problem, the TP-Link sends an ARP probing to see if the offered IP is in use, with the PROXY-ARP enabled it gets Linux responds to any ARP Request and the TP-Link understands that this IP is already in use and sends a decline . The solution was to disable the ARP Protocol on ...

Hello , After many attempts and all frustrated :( , not reached a consensus motif that happens only with routers TP -Link , friend someone can give me a light? I am sending the Log of an affected TP -Link . The problem aconcetece only if the Proxy- ARP is enabled on the shared interface. http://i62....

Hello Dmitry,

I performed more tests and found that disconnections occur only in TP- Link routers (crap ). I will check if there is any conf specifies that causes disconnections and I report . I have a client that has 130 access points and all are with TP- Link loadbalance .

Thanks.

Hello Dmitry,

With the proxy-arp disabled in vlan 0110 interface the problem does not occur when we enable proxy-arp in vlan0110 interface sessions begin to disconnect and are unstable, again disabling sessions remain stable.

Thanks.

Hi Dmitry, [2015-03-17 02:37:54.837] ipoe149: 960344a832ddba6a: recv [DHCPv4 Request xid=710e2f9f ciaddr=179.127.59.95 chaddr=c0:4a:00:dd:45:15 <Message-Type Request> <Client-ID 01c04a00dd4515> <Max-Message-Size 1500> <Request-List Subnet,Router,DNS,Route,Vendor-Specific,44,46,47,Classless-Route,249...

Hello everybody. I have a complicated problem, I have several clients on the same subnet in a shared vlan, these clients do not see themselves, so I enabled proxy-arp on the shared interface vlan and customers began to see, my problem begins when the proxy-arp is enabled, IPoE sessions are unstable ...

Hi Dmitry,

It worked, now I understand, I have to put the gw-ip-address parameter for each subnet that use.

Thank you for your help.

Hello everybody. I am deploying IPoE in our network'm with some doubts. Everytime I try to assign IPs by Radius Accel returns the following error. [2015-02-11 13:23:35]: info: ipoe0: recv [RADIUS(1) Access-Accept id=1<Cisco Cisco-AVPair "lcp:interface-config#1=rate-limit output 100000000 800000...