Accel-ipoe Upload Problem

Shaper related questions
Post Reply
rodrigoselau
Posts: 12
Joined: 13 Nov 2018, 12:32

Accel-ipoe Upload Problem

Post by rodrigoselau » 03 Dec 2018, 11:21

Good Morning,

I'm facing a problem regarding the shaper issue in accel-ipoe, when the shaper goes up, the upload rate is no more than 1mb, apparently the accel is not releasing the upload ... would it help me?

dimka88
Posts: 461
Joined: 13 Oct 2014, 05:51
Contact:

Re: Accel-ipoe Upload Problem

Post by dimka88 » 03 Dec 2018, 13:19

Hi, show [shaper] section from you accel-ppp.conf. And do you disable offloads from you interfaces?

rodrigoselau
Posts: 12
Joined: 13 Nov 2018, 12:32

Re: Accel-ipoe Upload Problem

Post by rodrigoselau » 03 Dec 2018, 16:53

[shaper]
#attr-up=230
#attr-down=231
ifb=ifb0
vendor=Cisco
attr=Cisco-AVPair
#up-limiter=police
#down-limiter=tbf

how do I do that ?

dimka88
Posts: 461
Joined: 13 Oct 2014, 05:51
Contact:

Re: Accel-ipoe Upload Problem

Post by dimka88 » 03 Dec 2018, 17:39

rodrigoselau wrote:
03 Dec 2018, 16:53
[shaper]
how do I do that ?
Like

Code: Select all

 thtool -K eth0 tso off gso off gro off tx off rx off rxvlan off txvlan off
set [log]level=5 and show part of log when session authenticate

rodrigoselau
Posts: 12
Joined: 13 Nov 2018, 12:32

Re: Accel-ipoe Upload Problem

Post by rodrigoselau » 03 Dec 2018, 18:09

Many thanks friend, it worked perfectly here for me: D

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest