Page 1 of 1

Accel-ipoe Upload Problem

Posted: 03 Dec 2018, 11:21
by rodrigoselau
Good Morning,

I'm facing a problem regarding the shaper issue in accel-ipoe, when the shaper goes up, the upload rate is no more than 1mb, apparently the accel is not releasing the upload ... would it help me?

Re: Accel-ipoe Upload Problem

Posted: 03 Dec 2018, 13:19
by dimka88
Hi, show [shaper] section from you accel-ppp.conf. And do you disable offloads from you interfaces?

Re: Accel-ipoe Upload Problem

Posted: 03 Dec 2018, 16:53
by rodrigoselau
[shaper]
#attr-up=230
#attr-down=231
ifb=ifb0
vendor=Cisco
attr=Cisco-AVPair
#up-limiter=police
#down-limiter=tbf

how do I do that ?

Re: Accel-ipoe Upload Problem

Posted: 03 Dec 2018, 17:39
by dimka88
rodrigoselau wrote: 03 Dec 2018, 16:53 [shaper]
how do I do that ?
Like

Code: Select all

 thtool -K eth0 tso off gso off gro off tx off rx off rxvlan off txvlan off
set [log]level=5 and show part of log when session authenticate

Re: Accel-ipoe Upload Problem

Posted: 03 Dec 2018, 18:09
by rodrigoselau
Many thanks friend, it worked perfectly here for me: D