So I had put accel-ppp live with heavy load

PPPoE related questions
hashbang
Posts: 80
Joined: 12 Jul 2015, 10:28

Re: So I had put accel-ppp live with heavy load

Post by hashbang » 04 Aug 2020, 14:49

hi,
thts good. The server I'm using is much powerful then 1270. The only problem I'd seen is. On high loads and there is network flapping affecting 1k ++ users then it starts misbehaving. Lots of start connections, lots of finish connections. Sometimes start goes more than the total users actually connected to server. Service restarts mysteriously. If there is no network flap then it runs smoothly

thanks and regards

hashbang
Posts: 80
Joined: 12 Jul 2015, 10:28

Re: So I had put accel-ppp live with heavy load

Post by hashbang » 04 Aug 2020, 14:51

what os r u using. I'm using centos 7 with el-repo kernel 4.4 kernel

lbw
Posts: 23
Joined: 09 Mar 2019, 00:16

Re: So I had put accel-ppp live with heavy load

Post by lbw » 13 Aug 2020, 12:56

I'm using Debian 9 but your issue sounds like it is more network related. Check your NIC buffers and your switch port buffers and statistics.

hashbang
Posts: 80
Joined: 12 Jul 2015, 10:28

Re: So I had put accel-ppp live with heavy load

Post by hashbang » 31 Aug 2020, 14:50

Hi,
I tried debian 10 but after all the tuning of NIC, conntrack I didnt got more than 500mbps and extensive packet drops on wan rx.
thanks

dimka88
Posts: 728
Joined: 13 Oct 2014, 05:51
Contact:

Re: So I had put accel-ppp live with heavy load

Post by dimka88 » 02 Sep 2020, 06:04

Hi, check NICs ring buffers and enable RPS

hashbang
Posts: 80
Joined: 12 Jul 2015, 10:28

Re: So I had put accel-ppp live with heavy load

Post by hashbang » 23 Sep 2020, 15:02

hi,
ty, Testing was done with all the tune ups. Same I got with centos 7 with el repo 4.4 kernel.

regards

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest