accel-ppp.org

hi,
thts good. The server I'm using is much powerful then 1270. The only problem I'd seen is. On high loads and there is network flapping affecting 1k ++ users then it starts misbehaving. Lots of start connections, lots of finish connections. Sometimes start goes more than the total users actually connected to server. Service restarts mysteriously. If there is no network flap then it runs smoothly

thanks and regards

what os r u using. I'm using centos 7 with el-repo kernel 4.4 kernel

I'm using Debian 9 but your issue sounds like it is more network related. Check your NIC buffers and your switch port buffers and statistics.

Hi,
I tried debian 10 but after all the tuning of NIC, conntrack I didnt got more than 500mbps and extensive packet drops on wan rx.
thanks

Hi, check NICs ring buffers and enable RPS

hi,
ty, Testing was done with all the tune ups. Same I got with centos 7 with el repo 4.4 kernel.

regards

Hi
Do you find solution of this problem?