cannot add pppoe interface in cli

[hashbang]

Hi,
I'd got 2 instances running.
instance 1 : ens5f1
instance 2 : ens4f1
On instance 2 i cannot add pppoe interface from accel-cmd. It accepts the command but no interface in show command. If u add the interface in conf file and restart the service. It adds the ppooe server on interface. Regular expression seems to be working. on 2nd instance in interface=re:ens4f1\.[1-1000]. Please assist
ty

[dimka88]

Hi, hashbang.

For different instance you have to use different [CLI]tcp=127.0.0.1:port and use this port as arg for accel-cmd

For instance 1:
accel-cmd -p <Instance 1 port> pppoe interface add ens5f1.100
For instance 2:
accel-cmd -p <Instance 2 port> pppoe interface add ens4f1.200

Code: Select all

accel-cmd -h
Usage:	accel-cmd [-v] [-4] [-6] [-n] [-f FAMILY] [-H HOST] [-p PORT] [-t TIMEOUT] [COMMAND]

	-f, --family	- Set protocol family to use for communicating with HOST. FAMILY can be set to "inet" (IPv4), "inet6" (IPv6) or "unspec" (automatic).
	-4		- Shortcut for --family=inet.
	-6		- Shortcut for --family=inet6.
	-n, --numeric	- Avoid name resolution for HOST and PORT.
	-H, --host	- Set hostname, or IP address, to communicate with. Defaults to "localhost".
	-p, --port	- Set remote port to use for communicating with HOST. Defaults to "2001".
	-t, --timeout	- Set inactivity timeout.
	-P, --password	- Set password for accessing HOST.
	-v, --verbose	- Verbose output.
	-V, --version	- Display version number and exit.
	-h, --help	- Display this help message and exit.

	COMMAND is the accel-ppp command line to be executed (if omitted, commands are read from standard input).
	The "help" command can be used (e.g. "accel-cmd help") to get information about available commands and their syntax.

[hashbang]

ty,
they are on different ports
accel-cmd -p 2002 pppoe interface add enp2s0f1.203

accel-cmd -p 2002 pppoe interface show

interface: connections: state:
-----------------------------------
enp2s0f1 0 active
in conf file
interface=enp2s0f1
if i change this to regular expression
interface=re:enp2s0f1\.
then it adds in cli
thanks

[hashbang]

bump
no one experienced this problem. I'll repeat the problem again.
if there is no interface added in conf file in pppoe section then giving this command doesnt add pppoe interface. You need to have one interface in conf file.
accel-cmd pppoe interface add enp3s0f1.222

results in no interface added.
and when you add this in conf file and restart the service. It gets added.

ty