Good Morning,
I'm facing a problem regarding the shaper issue in accel-ipoe, when the shaper goes up, the upload rate is no more than 1mb, apparently the accel is not releasing the upload ... would it help me?
Accel-ipoe Upload Problem
Re: Accel-ipoe Upload Problem
Hi, show [shaper] section from you accel-ppp.conf. And do you disable offloads from you interfaces?
-
- Posts: 15
- Joined: 13 Nov 2018, 12:32
Re: Accel-ipoe Upload Problem
[shaper]
#attr-up=230
#attr-down=231
ifb=ifb0
vendor=Cisco
attr=Cisco-AVPair
#up-limiter=police
#down-limiter=tbf
how do I do that ?
#attr-up=230
#attr-down=231
ifb=ifb0
vendor=Cisco
attr=Cisco-AVPair
#up-limiter=police
#down-limiter=tbf
how do I do that ?
Re: Accel-ipoe Upload Problem
Like
Code: Select all
thtool -K eth0 tso off gso off gro off tx off rx off rxvlan off txvlan off
-
- Posts: 15
- Joined: 13 Nov 2018, 12:32
Re: Accel-ipoe Upload Problem
Many thanks friend, it worked perfectly here for me: D