Problem when used shaper change
Posted: 21 Mar 2018, 18:10
Hi, I think I found another problem, now in the shaper module. When configured with Cisco attributes, the shaper change command removes the speed control and does not restore or apply the desired one.
when first connect:
now, check with tc (before change): tc class show dev pppoe987
now, change and check: accel-cmd shaper change pppoe987 7000/3000 && tc class show dev pppoe987
if using, for eg, Filter-ID, it works perfetly!
when first connect:
Code: Select all
pppoe987 | mk.244 | 100.69.197.102 | 5000/2000 | eth2.2244:08:00:27:CA:2E:93 | 08:00:27:83:6A:3C | 5fc46810ee75b49c | 874B | 362B | active | pppoe | 00:01:39
Code: Select all
class htb 1:1 root leaf 2: prio 0 rate 5Mbit ceil 5Mbit burst 8000b cburst 1534000b
class fq_codel 2:72 parent 2:
Code: Select all
(empty)
pppoe987 | mk.244 | 100.69.197.102 | | eth2.2244:08:00:27:CA:2E:93 | 08:00:27:83:6A:3C | 5fc46810ee75b49c | 874B | 362B | active | pppoe | 00:02:15