По результатам танцев с бубном обнаружил следующее:
пытаясь выяснить причину записей в kern.log
Code: Select all
Jul 16 02:52:01 ipoe-nas1 kernel: IPv6: ADDRCONF(NETDEV_UP): eth2: link is not ready
Jul 16 02:52:01 ipoe-nas1 kernel: 8021q: adding VLAN 0 to HW filter on device eth2
Jul 16 02:52:01 ipoe-nas1 kernel: IPv6: ADDRCONF(NETDEV_UP): eth2.3612: link is not ready
Jul 16 02:52:01 ipoe-nas1 kernel: IPv6: ADDRCONF(NETDEV_UP): eth2.3612.101: link is not ready
Jul 16 02:52:01 ipoe-nas1 kernel: IPv6: ADDRCONF(NETDEV_UP): eth2.3612.102: link is not ready
......
Jul 16 02:52:03 ipoe-nas1 kernel: igb 0000:01:00.0 eth2: igb: eth2 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: None
Jul 16 02:52:03 ipoe-nas1 kernel: IPv6: ADDRCONF(NETDEV_CHANGE): eth2: link becomes ready
Jul 16 02:52:03 ipoe-nas1 kernel: IPv6: ADDRCONF(NETDEV_CHANGE): eth2.3612: link becomes ready
Jul 16 02:52:03 ipoe-nas1 kernel: IPv6: ADDRCONF(NETDEV_CHANGE): eth2.3647: link becomes ready
....
Code: Select all
error: "Input/output error" reading key "net.ipv6.conf.all.stable_secret"
error: "Input/output error" reading key "net.ipv6.conf.eth0.stable_secret"
error: "Input/output error" reading key "net.ipv6.conf.eth1.stable_secret"
error: "Input/output error" reading key "net.ipv6.conf.eth2.stable_secret"
error: "Input/output error" reading key "net.ipv6.conf.eth2/3612.stable_secret"
error: "Input/output error" reading key "net.ipv6.conf.eth2/3612/1005.stable_secret"
error: "Input/output error" reading key "net.ipv6.conf.eth2/3612/101.stable_secret"
error: "Input/output error" reading key "net.ipv6.conf.eth2/3612/1012.stable_secret"
....
и т.д. для всех интерфейсов
И ещё вопрос - реально ли собрать accel на "родном" ядре CentOS 6 (2.6.32)?
Если реально, то что для этого необходимо "пропатчить"?
Собирается всё, кроме модулей ipoe и vlan-mon.
Ну и вдогонку - если с CentOS не получится, какая версия Debian предпочтительнее для accel?
Для тренировки пока собрал на "кошечке" на 9-м Debian.