hi,
thts good. The server I'm using is much powerful then 1270. The only problem I'd seen is. On high loads and there is network flapping affecting 1k ++ users then it starts misbehaving. Lots of start connections, lots of finish connections. Sometimes start goes more than the total users actually connected to server. Service restarts mysteriously. If there is no network flap then it runs smoothly
thanks and regards
So I had put accel-ppp live with heavy load
Re: So I had put accel-ppp live with heavy load
what os r u using. I'm using centos 7 with el-repo kernel 4.4 kernel
Re: So I had put accel-ppp live with heavy load
I'm using Debian 9 but your issue sounds like it is more network related. Check your NIC buffers and your switch port buffers and statistics.
Re: So I had put accel-ppp live with heavy load
Hi,
I tried debian 10 but after all the tuning of NIC, conntrack I didnt got more than 500mbps and extensive packet drops on wan rx.
thanks
I tried debian 10 but after all the tuning of NIC, conntrack I didnt got more than 500mbps and extensive packet drops on wan rx.
thanks
Re: So I had put accel-ppp live with heavy load
Hi, check NICs ring buffers and enable RPS
Re: So I had put accel-ppp live with heavy load
hi,
ty, Testing was done with all the tune ups. Same I got with centos 7 with el repo 4.4 kernel.
regards
ty, Testing was done with all the tune ups. Same I got with centos 7 with el repo 4.4 kernel.
regards
Re: So I had put accel-ppp live with heavy load
Hi
Do you find solution of this problem?
Do you find solution of this problem?